The CL3000 is a simple-to-use, configurable & powerful stand-alone CAN-bus analyzer. It is both a WiFi data logger with SD card and a wired CAN interface with a real-time clock.
The CL1000 is a simple-to-use, configurable & powerful stand-alone CAN-bus analyzer. It is both a data logger with SD card and a CAN interface with real-time clock.
The CL1000 is a simple-to-use, configurable & powerful stand-alone CAN-bus analyzer. It is both a data logger with SD card and a CAN interface with real-time clock.
The plug & play 2xCAN/LIN logger records timestamped CAN data (Classical/CAN FD) to the extractable 8 GB industrial SD card. The small device connects via WiFi access points (e.g. WLAN or 3G/4G routers) to securely push data to your server. Further, global fleets can easily be managed via over-the-air firmware & config updates.
The plug & play 2xCAN/LIN logger records timestamped CAN data (Classical/CAN FD) to the extractable 32 GB industrial SD card. The small device connects via WiFi access points (e.g. WLAN or 3G/4G routers) to securely push data to your server. Further, global fleets can easily be managed via over-the-air firmware & config updates.
It's a Network Analysis & Simulation Tool for CAN, CAN FD, NMEA2000, J1939, CANopen, LIN by Warwick Control Technologies.
Further maintenance which includes email support and updates for 1 year.
Year 1 is free since X-Analyser includes 12 months maintenance.
Year 2 is 25% of RRP
Year 3 is 75% of RRP to encourage customers to have maintenance
Year 4 or greater - 100% of RRP
CANCrocodile is designed for safe data reading from vehicle CAN bus. Contactless reader is used within vehicle telematics and GPS tracking systems for receiving various parameters of vehicle operation from CANbus: speed, RPM, oil pressure & temperature, fuel volume & consumption, etc.
Data reading occurs without electrical connection and without damaging CAN wires. CANCrocodile works in “listen” mode only, i.e. it does not change original J1939 messages and does not send any signals to CANbus.
Compatible for SAE J1939, CAN Open, DeviceNet, NMEA 2000
Nominal supply voltage: 12/24 V (5V – on request ; 2/24 A++ (low current consumption) – on request)
Current consumption: 300mA for “5V” version; 30/15mA for “12/24V” version; 10/5mA for “12/24 A++” version
Cable length- 0.7m (2 m– on request)
Cable connector- Molex/bare wires/Special connector (specify when ordering)
CANcheck: Installation tester for CAN networks CANcheck allows users to analyse CAN networks during commissioning, maintenance and helps searching faults. This battery-operated, hand-held device connects to the CAN network to be tested and operates using a clearly-structured menu.
Available in stock.